Difference between revisions of "Talk:Simple DVB with Gstreamer and GNU Radio"

From MyLabWiki
Jump to: navigation, search
(Logbook)
(Logbook)
Line 36: Line 36:
  
 
* Imported the source code to http://github.com/csete/gnuradio-dvb
 
* Imported the source code to http://github.com/csete/gnuradio-dvb
 +
 +
=== 2010.08.19 ===
 +
 +
* GMSK modulator generates 2 samples/symbol and I have 1 bit/symbol. Therefore, the input data rate to the GMSK modulator should be 500 kbps for a 1 Msps stream to the USRP.
 +
* The packet encoder adds 12 bytes overhead to each packet – at least when using default access code. With a payload size of 4000, this overhead corresponds to 1.5 kbps.
 +
* Setting H-264 encoder bitrate to 498 kbps (didn't make much difference).
  
 
=== 2010.09.03 ===
 
=== 2010.09.03 ===

Revision as of 21:04, 4 September 2010

Contents

Logbook

2010.07.24

  • Building on the success of transferring data between GNU Radio and multimon using a named pipe, I decided to try the same trick to send real time video from Gstreamer to GNU Radio. It worked!

2010.07.25

  • Implemented a simple video transmission simulator by sending the video through a GMSK modulator, adding noise, then GMSK demodulator. See recorded video.

2010.07.26

  • Although the MPEG-TS muxer available in Gstreamer can not deliver CBR, sending the GMSK modulated video to the USRP didn't seem to be a problem.
  • Having only one USRP I didn't try to receive and decode the video.

2010.07.27

  • Successful on the air tests of the DVB setup using a videotestsrc
  • Location: OZ7SAT

2010.07.28

2010.08.07

  • At Høm for the weekend and only brought one USRP and one laptop
  • Created a full duplex transceiver version of the GMSK TX+RX so that I could run both transmitter and receiver using only one USRP and computer: http://www.youtube.com/watch?v=dJg2zAd3kRY
  • The transceiver was running stable for more than 4.5 hours, see last screenshot.
  • With this setup, the video appeared to be more choppy than with the two-computer setup.

2010.08.08

2010.08.19

  • GMSK modulator generates 2 samples/symbol and I have 1 bit/symbol. Therefore, the input data rate to the GMSK modulator should be 500 kbps for a 1 Msps stream to the USRP.
  • The packet encoder adds 12 bytes overhead to each packet – at least when using default access code. With a payload size of 4000, this overhead corresponds to 1.5 kbps.
  • Setting H-264 encoder bitrate to 498 kbps (didn't make much difference).

2010.09.03

  • Tested Theora in Ogg container using videotestsrc and the simulator. Worked very well.

2010.09.04

  • Tested the Theora version using the gmsk_trx script. Worked well and very stable for 2+ hours using the videotestsrc.
  • With camera it looses sync after a few minutes and mplayer spits out "Ogg: bad packet in stream 0" messages.