Difference between revisions of "Making Time-lapse Videos"

From MyLabWiki
Jump to: navigation, search
(New page: This page describes the setups and techniques I am using to capture and create [http://en.wikipedia.org/wiki/Time-lapse time-lapse] videos. == Overview == The basic idea is very simple: ...)
 
(Logitech QuickCam Pro 9000)
Line 14: Line 14:
 
== Logitech QuickCam Pro 9000 ==
 
== Logitech QuickCam Pro 9000 ==
  
 +
The Logitech QuickCam Pro 9000 is UVC compatible<ref>http://quickcamteam.net/</ref> and therefore works extremely well with recent Linux kernels.
 +
 +
The control software to use is the [http://guvcview.berlios.de/ Gtk+ UVC Viewer].
  
 
== Post-processing using FFmpeg ==
 
== Post-processing using FFmpeg ==

Revision as of 22:58, 27 November 2009

This page describes the setups and techniques I am using to capture and create time-lapse videos.

Overview

The basic idea is very simple: Capture each frame of the video as individual frame of the video as an image and assemble the images into a video. Thus there are are two necessary parts in this process:

  1. A camera that can be controlled to capture images at regular interval. The delay between the frames depends on the length-ratio between the real-time event and the playback. For example, you want to create a time-lapse video with 25 fps of an event that lasts for 15 hours and you want the playback length to be 3 minutes. For a 3 minute video you'll need 4500 frames and over 15 hours this corresponds to capturing one frame every 12 seconds.
  1. Video encoder software that can take the recorded frames and encode them into a video. A good video encoder will also allow post processing, e.g. scaling and cropping.

An alternative technique can be used where one uses a regular video camera to record a standard video and converts the captured video using fast-playback. This technique is only feasible for short events up to an hours or so.


Logitech QuickCam Pro 9000

The Logitech QuickCam Pro 9000 is UVC compatible[1] and therefore works extremely well with recent Linux kernels.

The control software to use is the Gtk+ UVC Viewer.

Post-processing using FFmpeg

Processing is done in Linux using FFmpeg[2].

To convert the images called Image-1.jpg, Image-2.jpg, ... to a video in .mov format:

 ffmpeg -i Image-%d.jpg -sameq -r 25 timelapse.mov   (FIXME: Use -b instead)

To convert images captured in 4:3 at 1600x1200 to 16:9 format by cropping the top and bottom:

 TBD


Cite error: <ref> tags exist, but no <references/> tag was found